Monitor in robotron

Lastspaceship

Active member
vacBacker
Feedback
3 (100%)
Credits
205CR
Finally moved in robotron and think there might be a loose connection maybe in transit. Everything fires up but the image is displaying incorrectly. Doesnt seem to be "rolling" like a vertical sync issue, assumed something had come loose in transit, ie connecting to the video out. It's on a jrok (original board is in there). I reseated the video from there and checked around other connections, including into the chassis. Think I'm being thick. Any suggestions to check appreciated.

video:

https://www.dropbox.com/s/gr661r4wgb34j72/IMG_1540.MOV?dl=0

robotronscreen.jpg
robotron_wiring.jpg


Lastspaceship2022-10-31 13:11:22
 

Lastspaceship

Active member
vacBacker
Feedback
3 (100%)
Credits
205CR
On these the remote board is centred here right? I guess there would normally be knobs on it? was a bit cautious as adjusting when on.

controls.jpg


Lastspaceship2022-10-31 16:55:13
 

Lastspaceship

Active member
vacBacker
Feedback
3 (100%)
Credits
205CR
chefsolid said:
Those are the ones, I got some tiny plastic adjusters from Amazon but a small screwdriver will do the job carefully :)

Thanks ordered some, will give v-freq/ hold a tweak tommorow. Think it’s a 9000. Looked up the manual didn’t realise the big pot did contrast. Maybe it’s just a bit sensitive.

Help appreciated.
 

Lastspaceship

Active member
vacBacker
Feedback
3 (100%)
Credits
205CR
pinballaction said:
Adjust RV1.
Sorry for not sending the potentiometer adjusters.

thanks, no probs! sounds like it has one of your chassis in, was like this when I got it. all good, will tweak tomorrow. thanks for assist all.
 
Top