Hi guys
Recently the picture on my Hanty monitor in my Big Buck hunter cab had a reduced screen width for some reason.
So I tried adjusting the width on the remote board and I ended up with just a bright horizonal line on screen. I think one of the pots may have become loose.
I then noticed the final pin on the neckboard is bent back, probably from when I was swapping chassis so I'm assuming that is the fault. I tried straightening it back but with no luck as yet.
Can that be corrected or is it hasta la vista to the tube?
Any ideas?
Cheers
Dan
Recently the picture on my Hanty monitor in my Big Buck hunter cab had a reduced screen width for some reason.
So I tried adjusting the width on the remote board and I ended up with just a bright horizonal line on screen. I think one of the pots may have become loose.
I then noticed the final pin on the neckboard is bent back, probably from when I was swapping chassis so I'm assuming that is the fault. I tried straightening it back but with no luck as yet.
Can that be corrected or is it hasta la vista to the tube?
Any ideas?
Cheers
Dan