Monitor Issues help!

Chopper79

Active member
Feedback
8 (100%)
Credits
668CR
Just bought a thunder blade upright restoration project, with faulty monitor/board. When turned on the monitor at least has something going on, coloured lines etc, and you can see it is powered on. It is a wells gardner 19" monitor. I then thought, hang on a minute, the monitor in my super hang on, Is exactly the same monitor and chassis, even the serial numbers match. So I swapped the one from my super hang on into my thunder blade, and totally dead, and I mean dead!! Nothing....The only difference between the 2 that I can see, Is what I assume is the video input plug. The super hang on has a red plug with, a black/blue/green & red wires, and the thunder blade has a red plug with, white/blue/red & green wires. The wires are in a different orientation on both, but even reversing the connector doesn't do anything. Any ideas?

Here are the pics of the connectors. The top one is the super hang on. The bottom one is the thunderblade, but looking at the chassis side connector, looks like possibly been put wrong way round, because plastic is pushed out.

Webp.net-resizeimage.jpg


Webp.net-resizeimage_1.jpg
 

obcd

Active member
Credits
3,830CR
Just disconnect power and check with an ohm meter which pin is gnd. This should be the black wire and the white wire. The 2 chassis look identical, so only one way of the connector is correct. If your GND wire is correct, so should the other wires be.
 
Top