monitor issues

griffo83x

Active member
Feedback
30 (100%)
Credits
745CR
recently got hold of this cab

the monitor will not stretch out to full screen i have tried using the remote but i am still left with massive pal like boarders at the top and bottom of the screen
smiley7.gif
, any body know why

cheers

shinobimon.JPG
 

obcd

Active member
Credits
3,830CR
It's a rotated tube, so it's the horizontal width that is insufficient. This can happen if the B+ voltage is to low. You should measure it and you should know what it's suposed to be before you attempt to adjust it. If it's to high, a lot can go wrong on your monitor chassis.
 

Vamino

Insert coin(s)
vacBacker
Feedback
23 (100%)
Credits
2,698CR
I have no idea what the problem is, but I came across this vid when I was googling recently.
Best to get some other advice before messing though!
smiley2.gif


Vamino2015-05-28 21:03:06
 

joe34

Active member
Credits
448CR
im lost here, the horizontal width is bad? you mean its a vertical size problem...?
what happens when you adjust the vertical size pot, does no changes to the vertical size occur?joe342015-05-28 21:19:32
 

obcd

Active member
Credits
3,830CR
The picture tube is 90 degrees rotated, so the larger size goes from up to down. All markings on the monitor chassis are for a normal oriented picture tube, so basically, his picture is not wide enough. (It's the horizontal size that is insufficient from a chassis point of view.) If he adjusts the vertical size, the picture will become smaller or wider.
 

griffo83x

Active member
Feedback
30 (100%)
Credits
745CR
ok just watched the vid cheers ian I have adjusted the horizontal size doing this , but I still have the boarders top and bottom the vertical size :(
 

obcd

Active member
Credits
3,830CR
Do you have the brand and type of the monitor chassis? If not, a picture of it might help someone to identify it. The high voltage capacitors he is talking about in the video can normaly be measured with an AVO meter that has a capacitor tester.
 

joe34

Active member
Credits
448CR
tb lilley said:
Monitor doesn't look rotated to me. Shinobi is a horizontal game? In which case it's the vertical that's not large enough.
phew, i thought I'd entered the twilight zone for a minute.
 

obcd

Active member
Credits
3,830CR
My mistake.

It looked like a vertical game in the picture.

If vertical can't be properly adjusted, the monitor chassis might need some new capacitors.
 

griffo83x

Active member
Feedback
30 (100%)
Credits
745CR
yeh can do its just a standard looking one its the pot that says v-height it wont stretch the screen out anymore only shrink it . probably a cap problem ?

remote_pcb.JPG


griffo83x2015-05-28 23:30:26
 

griffo83x

Active member
Feedback
30 (100%)
Credits
745CR
gunblade said:
you need to measure the b+,btw how sure are you that is the correct chassis for tube?

hi grant yeh im not sure if its the correct chassis for the tube i only got these the otherday

http://www.ukvac.com/forum/2-video-wizard-mk-2-3-button-jamma-cabs_topic345303.html

as you see in listing polo monitors perfect working order ,this one has borders and the other one was burning out in the flyback cage as soon as i turned it on :(

but they both have the same chassis kortek not sure they both have the same tube but the one in the picture says thompson? not a hantarex polo in sight ??

paul

griffo83x2015-05-28 23:52:10
 
Top