Monitor Resistor Query

DABYX

User
Credits
109CR
Hi guys,

Another silly question from me.
Currently attempting repair of my electrohome g07 and the b+ wasn't high enough/adjusting so am testing all 900s.

Ive found a couple of resistors already I'll need to replace.
Now the manual calls for metal film resistors and from what I know they are generally better than carbon ones for heat and longevity.

However I'd rather get them all from one place if I can and the site I use only has carbon for some.

Would these be alright do ya think or would it be a bit of a gamble, especially as it's the hv areas?

Cheers,

Mike
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
i will be fine kinda, but don't

where it says carbon, try to use metal if you can

and where it says metal film then use metal film

they are better trust me

especially when it comes to timed electronics

metal film have a better tolerance and are generally more accurate
 

DABYX

User
Credits
109CR
Fair enough, figured as much but I don't know my arse from me elbow with this stuff
smiley36.gif


Shopping spree ahoy!

Cheers silverfox. :)
 

DABYX

User
Credits
109CR
Well some look like carbon to my untrained eye at least but noticed the manual calls for metal
smiley1.gif


Some values I need are
4.7ohm 3w 5%
47kohm 1/2w 1%
And 2.74ohm 1/4w 1%

It's all good though, the ones I can't get at my usual I'll probably just find on ebay.

Or I might ask the leccy chaps next door to my workplace ;-)
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
DABYX said:
Well some look like carbon to my untrained eye at least but noticed the manual calls for metal
smiley1.gif


Some values I need are
4.7ohm 3w 5%
47kohm 1/2w 1%
And 2.74ohm 1/4w 1%

It's all good though, the ones I can't get at my usual I'll probably just find on ebay.

Or I might ask the leccy chaps next door to my workplace ;-)

older chassis, the Metal do look like carbon but are indeed metal
rule of thumb follow manual, and when manual not available use metal to be safe
 

andrewsm

Active member
Feedback
1 (100%)
Credits
485CR
Metal film are as stated earlier, closer tolerances, higher wattage for size, plus flame retardant. Also another factor is they are less noisy as carbon can create noise in circuits.andrewsm2016-02-10 21:13:13
 
Top