Monitor Service

jonhughes

Active member
vacBacker
Feedback
52 (100%)
Credits
1,156CR
Does anyone local (or distant) perform monitor servicing on site? It's not something I want to do myself. I live in the Buckley area of North Wales.

I have two monitors (currently working) which could do with a clean and possibly a full capacitor replacement. I don't have the exact model of the monitors to hand but I'm just curious if anyone does this and how much they charge.

Thanks in advance.
 

forcefulfil

EDOT King
vacBacker
Feedback
17 (100%)
Credits
1,675CR
Ud still need to discharge the tube and post the chassis
Doubt anyone will do on site as its too time consuming aswell
As parts needed etc
Re caps are easy.we can talk u through it john
 

jonhughes

Active member
vacBacker
Feedback
52 (100%)
Credits
1,156CR
forcefulfil said:
Ud still need to discharge the tube and post the chassis
Doubt anyone will do on site as its too time consuming aswell
As parts needed etc
Re caps are easy.we can talk u through it john

Hi Phil,

I've fixed the monitor problem. It was a little frightening just to switch the thing on. The monitor was making a strange loud sound followed by strange fluctuating horizontal lines on boot up. The distortion would completely jam the signal to my radio in the same room and then return once the distortion disappeared.

I wish I had taken some photographs now, but there was a quarter inch layer of s**te on the monitor board and the tube. I had some fun removing the monitor first though. Anyway, cleaned up all the dust and everything else and the monitor is working just fine now (took me 4 hours in total to do). The crap must have been trying to create a bridge somewhere in the wiring or between parts. It didn't sound or look great.

I also worked out the problem with strange lines with the game board. There was a strange substance on the board (droplet size) which had burnt through two traces. The first one was easy to see but I didn't notice the short second one until I looked at another T-unit I was working on. The short trace was completely obscured from view by oxidation and burn. You can see the adjacent pins are pretty corroded. After connecting the second trace it works just fine now. Tricky little thing to do it was too. I just hope it lasts and doesn't develop anything else in the near future.

MK22b.JPG
 
Top