Hi guys,
Need some advice - I've got a cab that is wired for Wells Gardner and I've bought a Hantarex 9000 monitor to fit in it. I've ordered the cables and connectors for the Hanty chassis and I'm planning to splice the cables in rather than remove the original wiring in case it's ever needed in the future. Is it as simple as cutting the original wires and splitting them using terminal blocks? Also the Wells Gardner signal connector has a single wire for sync from the Jamma loom going to both the horizontal and vertical sync pins, is it the same layout for the Hanty?
Thanks,
Rich
Need some advice - I've got a cab that is wired for Wells Gardner and I've bought a Hantarex 9000 monitor to fit in it. I've ordered the cables and connectors for the Hanty chassis and I'm planning to splice the cables in rather than remove the original wiring in case it's ever needed in the future. Is it as simple as cutting the original wires and splitting them using terminal blocks? Also the Wells Gardner signal connector has a single wire for sync from the Jamma loom going to both the horizontal and vertical sync pins, is it the same layout for the Hanty?
Thanks,
Rich