Montior remote board

FixitFelix

Newbie
Credits
8CR
Recently bought an Atomiswave cab, it didnt come with the original monitor it came it an pentranic 29" pure flat montior(although there is a Samsung sticker on the tube).
The problem im having id the remote board seems to be missing 2 of the pots
smiley7.gif

Just wondering id this something that can be repaired or could i get a replacement?
Can upload pocs of the chassis of needed
6HdoTnm.jpg


Thanks for any helpFixitFelix2015-08-30 15:19:02
 

obcd

Active member
Credits
3,830CR
That aren't pots but small pushbuttons. You could simply solder 2 new ones in place. Farnell and RS components is selling those. (Make sure you don't pick smd ones) Just make sure you mount them correctly and not rotated 90 degrees.
 

obcd

Active member
Credits
3,830CR
There might still be some pots on the chassis, but the idea is that you press one of the buttons and get an overlay menu on the picture where you can select the setting you want to adjust. Once selected, you can use 2 of the other buttons to make the adjustment. For instance, for screen width, one button will make the picture larger, the other will make it smaller. The processor on the monitor chassis will remember your settings and set them equal the next time it sees the same video signal. So, most adjustments are done using the 4 pushbuttons.
 

FixitFelix

Newbie
Credits
8CR
Ok i guess ill have to sort something and try get new ones to solder on!! (Might be above my skill set)
smiley36.gif


Thanks for all your help lads will post back and see if its a success or not
 

obcd

Active member
Credits
3,830CR
You can temporary short the pins of one of the broken buttons with a piece of wire. It will have the same effect as pressing the button. One of those 4 should activate the overlay menu. obcd2015-08-31 07:58:07
 
Top