MTC-90 Troubleshooting

OTTOTHEMADANDEVIL

Will gyrate for Gyruss
Feedback
3 (100%)
Credits
328CR
I HATE this monitor!

Ive been shocked twice now
smiley19.gif


Can anyone offer up any advice on adjusting it, I get the feeling its a very fine art...

https://www.youtube.com/watch?v=xH9Zzn0hnbs&feature=youtu.be
 

jengineer

Senior Member
vacBacker
Feedback
49 (100%)
Credits
1,205CR
dude, how are you getting shocks?

try adjusting the pot ringed in red, I think you can get to it from the back of the monitor without dropping the chassis down



jengineer2015-02-13 22:16:32
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
it looks like a GND issue to me

the Video GND may not be gloabally connected to GND and just need a jump wire to any GND point

so connect Pin 14 of the edge connector to any GND point
 

gunblade

Active member
vacBacker
Feedback
23 (100%)
Credits
9,116CR
all right,screen volts too high and a ground issue
the ground issue is most likely to do with power supply,if it has a switch mode type link the earth and common
 
Top