MTC900E(USA) width problem

ttcaven

User
Credits
7CR
I have an MTC900E USA-model here (the one with the separate 3-pin connection for negative sync signals)
and I'm having troubles getting image to fill the screen area.

- inputting image from a Hyper Olympic board ( I got 2, a bootleg and an original, both same problem)

- monitor chassis recapped

- tested also with a Green Beret bootleg which seems to give a "wider picture" by default and therefore doesn't have this problem

- horizontal width coil has been rotated fully up and there's still 1cm black borders around the picture

- cap C42 unsoldered, tested for correct value and replaced with one of higher value as a test

- cap C69 unsoldered, tested for correct value and replaced with one of higher value as a test

Still no effect.

What to do, please help :(

Also note that there's a problem with both of the Hyper Olympic boards so that

they display wrong colours. The image is however stable as a rock.

I'm using the negative sync inputs.

Thanks,
Toni

ttcaven2015-05-25 10:17:00
 

ttcaven

User
Credits
7CR
gunblade said:
need to check your b+

Checked from SP20 as per manual with the G2 turned completely counterclockwise.

B+ was 114VDC, adjusted to 115VDC using RV12.

Adjusted the G2 to get picture back, and the +1VDC adjustment of B+

had no effect on picture width.
 
Top