multiboard screen position problem lcd

handbakedarcade

Active member
vacBacker
Feedback
6 (100%)
Credits
264CR
Hi

I have one of the 19in1 horizontal multi boards, the one with defender on it. I am trying to use it with a lcd but the horizontal position on the screen is way off. I have tried various different size screens and makes but no luck on any 4:3 models. Has anyone else had this problem or successfully used the board with a 19" lcd?

Thanks in advanced
 

Fuzzy

Active member
vacBacker
Feedback
18 (100%)
Credits
564CR
I used a 4:3 LCD monitor temporarily with an 19-in-1 a while back (while my chassis was away for repair) and seem to remember having exactly the same problem.

IIRC, I shifted the image as far as I could using the monitor controls, but it was still a bit out.

If it's any consolation at all, the image ratio/position on a CRT monitor is rather crap on the 19-in-1 too!
smiley36.gif


They're cheap for a reason, I guess.
smiley1.gif
 

taito6581

User
Feedback
2 (100%)
Credits
64CR
It depends on how your LCD interprets the VGA signal - dont forget that VGA is analog and therefor open for interpretation.

With the screen settings you can usually center it but then it depends on the VGA if those settings are saved.

The screens I currently use (bought from an out-of-business-sale website) dont save the settings on power disconnect. They store them on standby but unplugging them from the wall socket dumps the settings.

I suggest trying a different screen as it will react differently. on the 19-in-1 PCB there are no settings that I know of on how to display/position the VGA output.
 

handbakedarcade

Active member
vacBacker
Feedback
6 (100%)
Credits
264CR
i have tried a few different size/models of screen but all of the bar one small widescreen tv with a computer input behave in exactly the same way. Would you say trying to find a 19" LCD with the lowest native resolution would be best?

thanks.
 

andrew96

Unfixable? What's that word mean?
Feedback
1 (100%)
Credits
899CR
there usually 640 x 480 arnt they I believe so all lcd's will handle the input, as said above its how the lcd's are coded to deal with the analogue signal, some will work better than others, its just finding a lcd that likes it!
 
Top