Mvs1fz

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
I have the above mvs 1 slot that was working fine. I switched it off then back on and it now shows a calender error.

Any idea what could be the fault?
I did a quick google and some say change the battery.
Could this be the cause?

Thanks.
Steve
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
A bump to an old thread.
Just checked the battery and it is showing 2.01v
If I change the battery and holder will it clear the calender error?
If not would a mutibios chip help?
The only socketed chip is sp1. Is this where the uni bios would go?

Thanks,
Steve Steve2015-07-10 16:48:51
 

stevebm1

Active member
Feedback
39 (100%)
Credits
1,274CR
unibios will bypass the calendar,but might not cure all your problems,I think someone on klov made a special socket that fits over the exsisting chip to save desoldering it
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Just updated the thread. The only socketed chip on this board is sp1. Is that were the chip would go?
No battery leakage as I can see and the board is very clean.

Thanks
 
Top