Nwbie - Testing PCBs

Fazz_99

Newbie
Credits
4CR
I have bought a lot of 10 untested jamma boards on a blind auction. On collection it is obvious that they have not been stored well, outhouse or garage, they are filthy full of cobwebs etc.

2 are obviously damaged, i.e components unsoldered at one end.

However the others look viable.

I have two questions:-

Am I ok to plug these into my jamma cab to test, i.e if they are faulty (which is most likely) can they damage my cab ?

Second - if not working do they have a resale value for components ?

Many thanks for any help
 

Ace`

PlanB contributor #1
Feedback
40 (100%)
Credits
4,038CR
First make sure they are jamma, there are boards like sega 16 and early capcoms etc that have the same edge connectors but are not jamma. Plugging non jamma boards into a jamma harness will kill them.

Plugging dead / faulty boards into your cab shouldn't harm any thing, most modern switchers have built in short protection.

There's plenty of people looking to buy up faulty boards (myself included) either to repair or for parts.

If you aren't sure if they're jamma or what games they are upload some pictures.
 

Fazz_99

Newbie
Credits
4CR
OK the first two have components loose at one end so definitely not working. Rest look OK but I am no expert, I'm assuming they are prob faulty and bootlegs, one looks possible like only half of a two tier board. But if anyone can identify from pics it would be appreciated. Anyway particularly interested if any are NOT jamma before I test in my cab.

Sany0019brok.jpg


Sany0020brok.jpg


Sany0021a.jpg


Sany0022aa.jpg


Sany0023aa.jpg


Sany0024aaa.jpg


Sany0025a.jpg


Sany0026aaa.jpg


Sany0027a.jpg


Sany0028aaa.jpg
 

stevebm1

Active member
Feedback
39 (100%)
Credits
1,274CR
those are all jamma,bootlegs don't tend to have the cutout on pin 7,looks like most of those are streetfighter 2 bootlegs,and the half set marked tecmo,is the top board of world cup90
 

Ace`

PlanB contributor #1
Feedback
40 (100%)
Credits
4,038CR
Sorry to say but that looks like my scrap pile. The only one that isn't a bootleg is the WC90 but that's missing the bottom pcb.
smiley11.gif
Doesn't look like there's even any good bootlegs, all street fighters although I'm not sure what the forth one down is.

Hopefully you didn't pay too much for them, they're good for parts but not much else I am afraid.
 

Fazz_99

Newbie
Credits
4CR
Ha, no worries I was kind of expecting that. I'll stick to buying working boards. If anyone want to make me an offer for parts that's fine, if not i'll stick em on ebay (for parts)
 
Top