operation wolf help

kiels20

Active member
Feedback
3 (100%)
Credits
125CR
Right the mrs has gone out so its time to get my head back in this dam thing recived the credit board other day and it works lovely now takes all my money like it did back in the day thanks gunblade for pointing me to what credit board it was so hear i go . Soundboard time. Plugged it all in got my logic probe out and started checking the clock and reset on the z80 clock is fine and reset is there with no watchdogging so it seems to be working but no sound is comming out even changed the wires around too the other channel and still nothing this is about as far as my knowhow goes can anyone make the lightbulb come on that is hanging over my head or does anyone repair these ? thanks guys for getting me this far. Any help would be great as im so so close to putting this to bed
 

Body pop

Active member
vacBacker
Feedback
24 (100%)
Credits
1,266CR
Did you try wiring another spare speaker straight to the board
I got that advice here and it worked a treat .
Worth a try if you haven't already
 

bbz149

Active member
vacBacker
Feedback
26 (100%)
Credits
1,608CR
I would check the Amps are working 1st if you touch one of the legs on the pots VR1 or VR2 you should get speaker hum. The 2 chips with Heatsinks are the Amps. These boards are always going faulty! I managed to repair one of mine and kept a complete fully board-set
smiley4.gif
 

kiels20

Active member
Feedback
3 (100%)
Credits
125CR
Ha ha i aint got +13 volts but god dam it i had it six month back when i rebuilt the aux power supply strange verry strange gonna rebuild it again but it doesnt seem to be getting voltage across the fuses gonna give the fuse holders a good scrub or replace em so watch this space soon lol but thanks guys ye i tried putting the speaker streight to the board and obviously nothing lol be back soon
 

kiels20

Active member
Feedback
3 (100%)
Credits
125CR
Hear i go yet again. Right ive rebuilt the the aux power supply and cleaned the fuse holders and got my +13 volts back now ive got +13 at the amps and now i get speaker hum when i touch the vr1 and vr2 pots any ideas were i go from hear guys or what else i should be looking for ? Sooooo close
 
Top