Optoisolators logic probe

Nes4life

Active member
vacBacker
Feedback
12 (100%)
Credits
1,134CR
Hey all, I'm using a logic probe to see why player 1 button 1 and player 1 start are simultaneously pressing on my mega-tech when I put player 1 button 1 to ground. I've followed the traces to their ICs but going back over the route with the logic probe I can't follow the GND signal passed to the optoisolators. Obviously I understand they transfer the electrical signal using light and therefore keep the two circuits physically separate (potentially stopping high voltages entering the PCB). The logic probe is attached to the GND and 5v lines feeding the board. Measuring voltages, the 5v line is sitting at 5.6v and the voltage on the inner side of the optoisolators is at 5.4v.

So, how do you observe the received signals on the inner side of optoisolators with a logic probe correctly?Nes4life2014-11-02 20:14:16
 

obcd

Active member
Credits
3,830CR
Your buttons are static signals, so you can simply use a digital multimeter to check them out on the opto isolators.

Normally, the emitter of the opto transistor inside the opto isolator is connected to gnd and the collector has a pullup resistor to the 5V. When the opto transistor is conducting, it's collector voltage will drop close to zero volt. So, if you press the button, you should see that voltage go to zero and if you release it, it should go to 5V again.

Sometimes however, opto isolators are used to multiplex inputs. The buttons can still pull a signal to GND, but the collector and emitter of the fototransistor are part of a multiplexed switch input matrix. In such case it's difficult to tell what you should see on your logic probe without proper schematics. The only thing you know for sure is that the collector should conduct to the emitter of the fototransistor, so they should both have the same signal if the opto led is turned on.
 

obcd

Active member
Credits
3,830CR
A link to schematics (if you have such) might be helpfull.

Obvious, a video could also help in case someone else had the same issues.
 

Nes4life

Active member
vacBacker
Feedback
12 (100%)
Credits
1,134CR
Unfortunately I can't supply schematics as it's a Sega Mega-tech and the only schematics I've ever seen are high-level cab overviews / pinouts. I asked Sega directly for these once and they told me they don't support it anymore (cheers Sega!). I'll record my conundrum tonight if i've got the time.
 
Top