pac-man

I have spent many days trying to cure this fault and now very much need someone to point me in the right direction.
This game is basically on galaxian hardware and the board is made by sub-electro.

I have replaced the rams at 7p , 7n , 4f , 5f , 3f , 3h and about 10 other chips.

The game memory has been proved ok on another board.

I have a logic probe and oscilloscope.

Pictures didn`t appear , will try again.

positive logic2022-05-17 21:39:20
 
DCP05628.JPG
 

Macro

Active member
vacBacker
Feedback
4 (100%)
Credits
2,009CR
Looks like one of the counters are wrong, the 4 74161 chips around 4a (from memory, but there are 2 horizontal and 2 vertical counters)
 

Macro

Active member
vacBacker
Feedback
4 (100%)
Credits
2,009CR
Start with 6A, I'm guessing it's the V32 line being opposite to what it should be.

of course other things further down the chain could invert it as well, but follow it through from there.

why I decided it was horizontal, no idea, but those 74161's are from 3A to 6A - so check them all
smiley2.gif

Macro2022-05-18 08:35:02
 
Thank you Macro , i know the counters you mention.
I did use the galaxian video probe ( resistor on piece of wire ) and one of the outputs matched exactly the wrong spacing where things are cut off on the screen.

I will report back soon.

Robin
 
Reporting back on what I've done as the board is still faulty.
I`ve traced the 32V signal from ic 6A pin 14 using the scope.

I`ve followed the signal to 6B pin 12 and comes out on pin 11, then 4N pin 3 and out on pin 1 although the signal more difficult to read now as mixes with the horizontal signals.

I`ve compared with the 16V & 64V lines and nothing looks suspicious.

I replaced 3M , 5C , 4A & 6E.

I have checked all outputs on 161`s 3A to 6A and changed 4A because output pins 11 & 12 were very similar.

Robin
 

Macro

Active member
vacBacker
Feedback
4 (100%)
Credits
2,009CR
Is it the correct signal, i.e if you look at the 128v with video probe half the screen will be black (logic 0). The 32v should start with black on the same side if it starts green (or whatever, my probe is in green) then the signal is inverted.
 
Thank s bones for suggesting the lawnmower man site , there was a fault very similar to mine where the sn74ls283 was faulty so i replaced this anyway but the fault remained.
Thank you for the offer to borrow your board keptboy but i already have a working identical board and believe me it has been compared many times.

Thank you for your suggestion macro , i will check this out this evening.

Robin
 
Macro you were spot on , the board is now working correctly.
The galaxian video probe showed that the 32v signal at pin 11 of the 7486 at position 6B was inverted.

The 74161 counter at 6A feeds into the above 7486.

Thank you for your help macro.

Robin
 
Top