PacMan repair

simonden

Active member
vacBacker
Feedback
20 (100%)
Credits
1,042CR
Hey guys,

Got an original Midway PacMan in an original Midway cab. The game plays fine, but the red is about 2 pixels higher and 1 pixel to the right of the other colours. PCB issue? or monitor issue? Monitor is an Electrohome.

I have a spare (non-working) PCB and most chips are socketed so hoping it is just a case of a monitor adjustment or swapping a socketed chip.

Cheers
 

simonden

Active member
vacBacker
Feedback
20 (100%)
Credits
1,042CR
OK next question, how do I fix monitor convergence on an Electrohome, is it just twiddling a knob
smiley1.gif
 

simonden

Active member
vacBacker
Feedback
20 (100%)
Credits
1,042CR
Cheers guys, it is definitely the monitor convergence magnets. It is OK to touch these with fingers while the monitor is on? Or am i going to get zapped?
 

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,087CR
I wore a rubber glove, last time I did it.
smiley17.gif
It just gives me more confidence. Being nervous when adjusting stuff like this is a sure way to get zapped, due to not paying enough attention. Look out for the yoke voltage terminals, as they're usually near the rings and exposed. Well, that's my advice, but it could well be a load of b*ll*cks.
smiley36.gif
big10p2016-12-14 00:05:01
 

simonden

Active member
vacBacker
Feedback
20 (100%)
Credits
1,042CR
It is definitely the monitor convergence, remembered PCB was same pin out as Galaxian apart from sound so swapped PCBs over. I have since adjusted the rings by using a rubber handled tool as I was too scared to touch it and almost fixed the red, but now pushed blue and purity out as some of the other rings turned at same time. So need to do with hands really.
 
Top