Paperboy controller help needed!

shrunkenmaster

Active member
vacBacker
Feedback
2 (100%)
Credits
162CR
Anyone know how to get the roll pin out?

Screen_Shot_2014-01-21_at_15.09.35.png
 

cmonkey

Active member
vacBacker
Feedback
4 (100%)
Credits
1,659CR
Looks like you'd simply have to drive it out with a similar (slightly smaller diameter) kind of pin. The Out Run gear shaft uses a similar kind of rolled pin to attach the shaft to the main body. I used a slightly smaller diameter bolt to drive it out.
 

PaulSwan

ZZZ
Feedback
1 (100%)
Credits
1,118CR
A screw driver tends to dig into the pin a bit if it's seized up. I've used the male hex versions of those cheap jewelers sets before - because the hex head is solid and the contact with the pin is all the way round it doesn't dig into the pin you can give it a good whack :)
Paul.
 

Bensonrad

STILL looking for an Outrun & Paperboy!
vacBacker
Feedback
68 (100%)
Credits
940CR
Do you have a Paperboy Shrunkenmaster? I may call upon you to come help fix mine! as you are close by, haha.
 

Russ J

Active member
vacBacker
Feedback
1 (100%)
Credits
233CR
shrunkenmaster said:
Pretty much what I thought, similar to the b*tch of a pin on the Star Wars yoke!

This is the first thing I thought of when I read the thread title...the Yoke pin...funny thing is when I restored my SW yoke the said pin wasn't there in mine...strange
smiley5.gif
...Still it made it easier for me to fully strip it down
smiley4.gif
 

shrunkenmaster

Active member
vacBacker
Feedback
2 (100%)
Credits
162CR
Bensonrad said:
Do you have a Paperboy Shrunkenmaster? I may call upon you to come help fix mine! as you are close by, haha.

Unfortunately not - just the handlebars! Looking for a donor System 2 cab...

Also, I don't suppose anyone has a spare anchor nut & anchor pin? Mine just disintegrated
smiley19.gif
 
Top