Pentranic 1125 vertical collapse!

Ronnie Dent

Active member
vacBacker
Feedback
15 (100%)
Credits
1,206CR
Just picked a cab up today with this monitor, it has vertical collapse, the remote board was damaged and someone has replaced a pot but I don't know if the correct one was used! The board had a chunk missing along the edge of one of the connectors so the pins were adrift! I resoldered these but still collapsed! Could a bad remote kill the vertical chip? Also is there a schematic around to get the value of the replaced pot?

Thanks Ronnie
 
Last edited:

Ronnie Dent

Active member
vacBacker
Feedback
15 (100%)
Credits
1,206CR
Ok it’s a CH-288 chassis, I replaced the vertical ic and I still have collapse! I checked r336 and d401 they were fine, the chassis looks nice and clean so it’s been a replacement screen at some point as the chassis frame has a hantarex polo sticker

The vertical pot on the remote board is correct at 5k as this has been replaced

IMG_3672.jpegIMG_3673.jpegIMG_3673.jpeg
 
Top