Phoenix PCB

jonhughes

Active member
vacBacker
Feedback
52 (100%)
Credits
1,156CR
Hi everyone,

I'm currently repairing a Centuri PCB. It seems to be operating fine except for two issues.

1) The ship is constantly pulling left. The input for left leads to an 8 commoned 1k ohm resistor pack which is reading 15 ohms on that terminal and 1k on all the others. This then leads to IC12 an HD74157P chip. Is the likely fault the resistor pack or the IC chip? Or will it go further up the trace tree? I'm poor at identifying what components do
smiley9.gif


2) The melody chip has blown at IC49 a MN6221AA. Is there a cheap alternative to this chip? Little diode are selling them at £10 per chip without P&P which I feel is steep.

Any help greatly appreciated.
 

Equites

Chief Sheesher®
vacBacker
Feedback
35 (100%)
Credits
3,329CR
Jon, send me you address and I will wing you a couple of Ls157. Likely those.

The melody IC at a tenner is very reasonable.
 
Top