Problem with a MS8-29 FSG

obcd

Active member
Credits
3,830CR
Has this combination monitor - game board ever worked.

It looks like a wrong sync, like a 25khz monitor on a 15khz game board or the other way around.

A bad ground connection between the game board and the monitor could cause this as well.
 

Frondelius

Newbie
Credits
2CR
Hello .
Code:
I do not know if this combination has worked in the past but the screen can be switched between 15 and 25kHz . The first time I started the game was the monitor set to 25kHz , which worked even worse. When the film was shot is at 15kHz .
 

cosine

Active member
vacBacker
Feedback
14 (100%)
Credits
595CR
I've had capcom boots in the past that have crap or no grounding on video sync. Might be worthwhile soldering a wire from pin1 to pin14 on the part side of the JAMMA connector, see if that stablises things.
 

Frondelius

Newbie
Credits
2CR
Hello again.
It works now!! It was the missing video ground signal.

Thank you for all your help.

I have a new question but I start a new topic on that.
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
cosine said:
I've had capcom boots in the past that have crap or no grounding on video sync. Might be worthwhile soldering a wire from pin1 to pin14 on the part side of the JAMMA connector, see if that stablises things.

taito boards are the same
PCB itself has no Video Ground globally connected so requires it on the loom
 
Top