Quick Polo question **Fixed**

obcd

Active member
Credits
3,830CR
Isn't that black wire on the right of the screw you are pointing 2 suposed to be the ground wire of the chassis? I have personally never seen the fixation screw being used for that. There is a dedicated one, either on the metal surrounding the pcb, or on one of the 2 frames that support the picture tube frame. Just my 5 eurocent (or should I say pence)
 

Del Griffith

Active member
vacBacker
Feedback
17 (100%)
Credits
844CR
obcd said:
Isn't that black wire on the right of the screw you are pointing 2 suposed to be the ground wire of the chassis? I have personally never seen the fixation screw being used for that. There is a dedicated one, either on the metal surrounding the pcb, or on one of the 2 frames that support the picture tube frame. Just my 5 eurocent (or should I say pence)

You're probably correct with the screw to the right instead
 

Nooch79

Newbie
Credits
4CR
The saga continues....

Ok, i sorted the power, finally the monitor is alive and showing a crisp picture...but.. why is the SNK logo red? Why are characters faces/bodies blue? and why suddenly does the game select button give me credits????
 

muddymusic

The Repro Guy. Art and Parts supplier
Staff member
vacBacker
Feedback
52 (100%)
Credits
2,265CR
Red & Blue inputs on the monitor need to be reversed. Hantarex changed them over from the 900 to the Polo.
You could take the pins out of the green connector and swap them over.

I'd guess the select buttons adding credits is something deliberately wired up by a previous owner. Although you can just put free play on in the dip switches.
 

Nooch79

Newbie
Credits
4CR
So the US250 wasn't being used for the Polo?
I take it the red & blue you're refering to is on the other green connector and i need a special tool to remove them?

Also, the select button has always been select when more than 1 cart has been inserted it's never affected credits before.
 

obcd

Active member
Credits
3,830CR
I don't know about mvs, but some systems have an input testing, showing you which inputs (buttons) are activated.

It could be a board fault or a cable fault.

Normally, buttons connect an input to ground when they are pressed.

So, you could check the coin switch voltage when you press the select button.

It shouldn't change unless that button and the coin switch are wired together (or having a short somewhere). Multiplexed inputs like you find on pinballs are another story.
 

Nooch79

Newbie
Credits
4CR
Check it out!!..
20150922_122151-1.jpg


All seems to be ok.. yay!
Switched the red/blue as Muddy suggested and bam! Working nicely

smiley32.gif
 
Top