quick question about Net City locking bar

soop

Newbie
Credits
43CR
I picked up the bar that screws inside a Net City control panel with two hooks on either side and a torsion spring. I had imagined that it would clasp tight to the square metal loops directly above, but upon fitting mine, it still allows the top part to open ~4cm or so. Is this correct? or is it supposed to latch tightly as I was expecting?

I don't see how I could have gotten it wrong. It fits, it's orientated correctly, I've checked phots
 

soop

Newbie
Credits
43CR
nah should
Lock it tight .

Can compare tomorrow ..
I took pics to show as best as I could what the issue is. Fully closed, there's only about 4cm between the screw post and the bottom of the catch, and the interface of the locking bar is about 10cm tall. I don't think there's any way to orient it such that it would ever lock properly. I did get the bar from the same seller I got the panel from, but maybe it's from a different X city machine? Or am I doing something wrong?
 

Attachments

  • 1000202386.jpg
    1000202386.jpg
    40.4 KB · Views: 13
  • 1000202385.jpg
    1000202385.jpg
    58.2 KB · Views: 12

soop

Newbie
Credits
43CR
Cool ..
I have a looking bar loose I can grab and take a pick with tape measure next to it to show its size
ok, here are two more bigger pics. I tried to show one where the shell is fully closed and the bar doesn't fit, and another where the bar is locking the catches somewhat, but the shell won't close
 

Attachments

  • 1000202477.jpg
    1000202477.jpg
    122 KB · Views: 6
  • 1000202479.jpg
    1000202479.jpg
    132.5 KB · Views: 6
Top