Renegade

paulcan69

Can reburn OTP EPROMs! Fear my power!
Feedback
11 (100%)
Credits
945CR
All the fm sound samples on renegade are a bit loud scratchy and humming
The humming gets worse as the pcb warms up
The fm chip is a Yamaha ym3526
If I put my finger under it once it's running me acting as a gnd helps calm the hum down
Any ideas?

Someone has socketed it so I guess I need to check that first yeah?paulcan692015-06-21 20:24:27
 

paulcan69

Can reburn OTP EPROMs! Fear my power!
Feedback
11 (100%)
Credits
945CR
Saying that the socket looks factory??
The hum just gets louder and louder once the pcb is on

Not sure if I think it's the fm chip or the amp

Can a cap do this?

Sfx and main music are fine
Fm synth only?!?
 

andyJay

User
vacBacker
Credits
98CR
have you got a heatsink to put on it paul? sometimes old c64 sid chips do something similar,shoving a heatsink on helps most of the time.
 

andyJay

User
vacBacker
Credits
98CR
none of them had them! a lot of the chips run 60C+,not good if you want to keep a chip going for a long time!

commodore also had the great idea of sticking a bit of foil cardboard over the whole board..just goes to show how good these old chips are to last that long and still keep going,older breadbin 64s tend to come soldered,the newer 64c tend to come socketed.

think i might be going round my boards with a temp gun now :)
 

paulcan69

Can reburn OTP EPROMs! Fear my power!
Feedback
11 (100%)
Credits
945CR
Ok replaced a few caps that were poor according to my esr meter
I replaced the two ha17558 op amps
Still as it warms up (after 5 mins of playing) the fault is still there

Next is this 3014b chip as I wait for a few from china I might fire up the scope to test it
Please can I have an idiots guide to checking it
Obviously one on any gnd on the pcb, or do I have to gnd it to the chip?
And what pins on the chip can I scope?
And what setting to set the scope to?

Please?

All that leaves is amp? Maybe but is fine for a bit and it's only the fm synth sounds which are effected

Or the ym3526 on renegade it's socketed

On Wikipedia it said bubble bobble uses one, I looked at that and it's not socketed and no way am I desoldering it for a mere renegade pcb lol

Any other games which use it which might be in a socket?

Thanks
 

ben76

Hunts Spies
Feedback
7 (100%)
Credits
1,136CR
I have loads of YM3812's off scrap boards.... the reason I say this is as on the bubble bobble boot I looked at it had one on it not a YM3526. If you can find any difference lmk also if you want a few to try lmk
smiley1.gif


http://www.atkinsoft.com/datasheets/ym3526.pdf

and

http://www.alldatasheet.com/datasheet-pdf/pdf/84281/YAMAHA/YM3812.html

- Ben
 
Top