Replacement Tripler

Mr20to5

Active member
vacBacker
Feedback
1 (100%)
Credits
1,366CR
Hi guys.

I recently acquired a lovely burn free 14" crt from a good friend on here.

It was given as faulty and its the tripler that is goosed and needs replaced.

The difficulty is that this one has a focus pot attached and the universal ones I can find online don't. I'll put some photos below of the offending part.

Anyone got any thoughts or spart parts? It's a mitsubishi monitor with a microvitec chassis. The EHT tray has the numbers T30 N112 written on it.

Thanks in advance. Clearly I would love to get this working again.

I did find this link, is it any good?
clicky link

20161129_161002_zpskbvxo3zr.jpg


20161129_160933_zps2ixn9cs2.jpg
 

jengineer

Senior Member
vacBacker
Feedback
49 (100%)
Credits
1,205CR
from reading other peoples views on these I personally wouldn't touch them, Gunblade says they hold a charge like no other monitor so be careful when working on it

if you feel brave then I have a manual/schematic for a Microvitec which I can dig out for you if you need one?
 

Mr20to5

Active member
vacBacker
Feedback
1 (100%)
Credits
1,366CR
jengineer said:
from reading other peoples views on these I personally wouldn't touch them, Gunblade says they hold a charge like no other monitor so be careful when working on it

if you feel brave then I have a manual/schematic for a Microvitec which I can dig out for you if you need one?

Nice! I have a friendly tv repair dude to do the work, if and when I can find the right part......
 
Top