RESISTOR IDENTIFICATION!

Gaming Heaven

Active member
Feedback
6 (100%)
Credits
106CR
Guys need help what is this resisitor....?

is it 680 m ohm am I right and what is the best place to order?

one of the legs broke off and not sure if it is feasable to solder, seems an impossible job

thanks in advance:

blue
grey
pink [or violet?]

stripes starting from the top and going down, with white spot on the top
bulbous type

[pic to follow asap as I can't get access tonight]
 

obcd

Active member
Credits
3,830CR
Even if you can't solder the broken leg, you might still be able to measure the resistor value.

680M is a giant big value for a resistor. Maybe if you could tell us where it's used in, we might be able to determine if it makes sense to have such value on that place. Sometimes the rings decolorate a little over the years.
 

Gaming Heaven

Active member
Feedback
6 (100%)
Credits
106CR
guys thanks for the replies

here it is at the top:

it is the daughter top board for a "the invaders", there is no writing on it so I presume not a capacitor?

sound was working then 2 of the 4 sounds stopped and I noticed the broken leg but not 100% sure it is that but makes sense, the main chip on this board I presum processes sounds and there are then 4 daughter chips that maybe modify the data? I don't believe schematics exist so I am a bit clueless

102_0381_2.jpg

Gaming Heaven2015-08-12 19:04:17
 

mathj

Active member
Feedback
5 (100%)
Credits
499CR
I am no expert so I may be wrong but is that a tantalum bead capacitor?
I only know as I replaced a load on my space invaders power supply

cant help with the values though, are there any numbers on it?

also I don't know if the invaders is similar to taito hardware but the sounds are generated by a line of lm3900 chips on the taito pcbs, could it be the same on the invaders hardware?

math

mathj2015-08-12 19:13:18
 
Top