Screen positioning between 2 pcb's

Retrojedi74

Active member
Feedback
1 (100%)
Credits
86CR
Hi all, just wondering if somebody could give us some advice regarding screen position between two different pcb's ( 19 in 1 horizontal pcb & a 512 in 1 pcb ). When I put in the 512 in 1 and align the screen up it's fine but when I change to the 19 in 1 the screen is right of centre and it means me having to realign the screen every time. Is there a way of aligning both up so when I change I haven't got to realign again. Thanks in advance guys
 

Monstermug

Active member
Feedback
23 (100%)
Credits
1,807CR
Welcome to the joys of arcade pcbs
smiley36.gif


Trick is to underscan and average out the two and live with the gaps :D

I normally keep my pcbs inside for several months so it's worth adjusting for perfection.
 

Fantazia2

Active member
vacBacker
Feedback
13 (100%)
Credits
2,246CR
Dont think there is much you can do about that, its just the different way the 2 boards position the video.

Its usual for the same to happen between different types of regular arcade PCBs as well when swapping in a Jamma cab.

Also with that 19in1 you will find that different games on the board will have different border sizes as well.

Unfortunately is just something you have to live with.
 

Flinnster

The Dino King
vacBacker
Feedback
29 (100%)
Credits
2,566CR
Yep for sure it's a pain in the arse. Bootleg boards all seem to have wildly varying video outputs too.
I guess these boards were designed originally to be popped in cab,
set-up by the operator in a short timeframe and then left running for
anything from a month to a number of years without too many adjustments.
Totally different to us using the same kit today, and swapping around
games more like having a games console collection.

You just have to tweak the output to best suit the game in use, or find a setting that deals with 'most games' in the collection OK.
I tend to use my MVS and PGM motherboards to find that happy average. And I have Dino Kings with no remote monitor boards! It's a -real- pain in the ass to get to the monitor pots!
 

grobda

"Look at the size of that thing!"
vacBacker
Feedback
7 (100%)
Credits
1,061CR
having a remote adjustment pcb somewhere accessible helps. I wired an extension cable to one of my cabs to do this, the other had one already. Also fit knobs to the adjustment pots. Other than that swap games less, get better at the one in the cab ;)
 

Retrojedi74

Active member
Feedback
1 (100%)
Credits
86CR
Thanks everyone, I thought this must be the case but I thought if there was a remedy to it someone on the forum would know.
I'll try and tweak it between the two to get the closest fix.
Thanks again
 
Top