Screen printing touch up

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
I have a gorf tabletop that has a few bits of the screen print flacking.
Luckily it is around the edges on the black.
Has anyone tried touching up the screen print on one of these?

If so what type of pait should I use and does it work and look ok afterwards?

Cheers,
Steve
 

muddymusic

The Repro Guy. Art and Parts supplier
Staff member
vacBacker
Feedback
52 (100%)
Credits
2,264CR
I use a edding paint markers, they apply straight to glass and the black & white in particular will give a very good finish. If you go over the flaking edges it also acts as a seal on the remaining art.

The range of colours is quite good too.

http://www.cultpens.com/acatalog/edding_750_Paint_Marker.html

Acrylic paint is another good option. I've also used spray cans but found the finish wasn't as even as with the paint pens.
 

Dex-Jay

Active member
Feedback
4 (100%)
Credits
375CR
From my experience I'd say don't use Acrylic - use enamel. Acrylic doesn't cover as well as enamel. I'd suggest Humbol Hobby paints (like you'd use on plastic model kits)

Here's a before and after of my Pac-Man bezel (glass of course). I've not started a thread yet with my restoration but I will soon (if anyone wants to see it!)

pac1.jpg


Pac2.jpg


I nearly went the strip it all off and go repro but thought, well I'll give it a go and if it all goes Pete Tong I can always strip later.

Give it a go!
smiley2.gif
 
Top