Sega Force Feedback

obcd

Active member
Credits
3,830CR
I am trying to find more information about the steering force feedback board that is used in a sega outrun2 and some other sega cabs. The Steering board seems to have a separate connection to the chihiro. On the wiring diagram, you have TX TXR RX and RXR. I tried to follow some of the pcb tracks, and the TX has a 220 ohm resistor. After that resistor, it's connected to a sharp PC410 high speed optocoupler. The RX also seems to have the 220 ohm resistor. I haven't checked but I expect to find the same opto on the Steering board. It looks like an optical isolated serial interface. I googled, but couldn't find any attempts at understanding how the communication protocol with the board works. I found systems modifying a logitech steering wheel feedback reusing the feedback potmeter and motor, and I found some designing a complete new interface board to control the force feedback motor and clutch of a sega daytona.

So my question is, are there some people who might know more about the part of this iceberg that is under water?

The idea is to be able to control the cabinet hardware with something like a pc. JVS is well documented. The audio is just a couple of analog cinch plugs. The steering force feedback interface seems to be a missing piece of the puzzle. (Altough it's not a puzzle but a racing cab.)
obcd2015-10-17 12:21:16
 
Top