I am working on my sega racing cab,, and I have experienced a power problem.
When on first test, I just powered up the ATX psu, for the main boards, and that worked fine, however the amplifier and the Motor control board require 12.8vac and 110vac respectively.
The system has a transformer in it, which I wired up today.
I didnt put any device on the output, as I just wanted to test the output voltages first.
When I turned it on, the lights in the garage flickered....
Voltages were good !
When I turned it off, it tripped the circuit breaker...
Any ideas ?
Thanks
Simon
When on first test, I just powered up the ATX psu, for the main boards, and that worked fine, however the amplifier and the Motor control board require 12.8vac and 110vac respectively.
The system has a transformer in it, which I wired up today.
I didnt put any device on the output, as I just wanted to test the output voltages first.
When I turned it on, the lights in the garage flickered....
Voltages were good !
When I turned it off, it tripped the circuit breaker...
Any ideas ?
Thanks
Simon