Snow Bros RAM

guddler

Busting vectors like it's 1982!
vacBacker
Feedback
10 (100%)
Credits
4,058CR
Is anyone that has a Snow Bros board (working of course!) willing to spend some time to beep out the connections to / from / between the 4 x 4464 RAMs at the bottom of the PCB please?

Bought the non worker from SteveBM last week. First stop was to re-do the soldering on the 4464 sockets as it wasn't looking too clever. Took me about 3 hours to clean it all out due to it being a multi-layer PCB, and a particularly nasty one at that. There were a number of broken tracks and pads. I believe I've patched them all up OK but I need to check.

The 16Mhz crystal was also dead so that has been replaced and on top of that the 68000 was also not working. After replacing the 16Mhz Oscillator, the 68000 and all the 4464 RAM the game is up and running but with some quite serious graphics issues. So I need to double check my work on the 4464's before I go much further and start pointing fingers at the Pandora GPU (hoping it's not that, this looks like quite a cool game!)
 

stevebm1

Active member
Feedback
39 (100%)
Credits
1,269CR
glad you made some progress with it,those ram sockets were not fitted by me,it was like it when I got it,I guess the board had issues in the past and a previous owner had attempted repair
 

guddler

Busting vectors like it's 1982!
vacBacker
Feedback
10 (100%)
Credits
4,058CR
lol! well I didn't want to say anything too much as I didn't know if you'd tried to fit them or not and therefore didn't want to offend
smiley2.gif
Whoever did them, it doesn't look like they had a good enough / hot enough iron as most of the solder points were just blobbed up and not flowed through. Multi-layer PCBs are a bitch too!

I played this on the Amiga last night and it's a great game so I'm going to put the effort in and hope that I can fix it.
 

stevebm1

Active member
Feedback
39 (100%)
Credits
1,269CR
it is a great game,I used to play it in our work canteen years ago,but I get my fix on the multiboard version now,I bought a beat up jamma cab,for the monitor as it was working,and that was one of the pcb's I got with it,the guy said he used to get his pcb's fixed by someone in plymouth,but the guy was about 80 now,and he didn't think his eyes were up to it anymore
smiley36.gif
 

karlcdoe

Active member
vacBacker
Feedback
8 (100%)
Credits
887CR
Snow Bros is a fun game, I have had the pcb from virtually new though sadly it's a bootleg version so not much use to you for testing I suspect.
 

jonhughes

Active member
vacBacker
Feedback
52 (100%)
Credits
1,156CR
I've got a working board, well it was the last time I plugged it in. Unfortunately, I've been in Portsmouth working since Sunday and not likely to be home until late Friday evening (providing I can leave). If no one steps forward between then, I'll be happy to assist when I'm back home.

Not sleeping great here either, want to be home, you can tell by the post time
smiley6.gif
 
Top