Space Invaders cab front swap

slowcade

Active member
Feedback
1 (100%)
Credits
204CR
Can the front of Taito Space Invaders cabinets be swapped? I want to combine two cabs to make a beautiful one.. and another one.
I think I saw it mentioned here just recently, but I am unable to do it. The front panel goes into vertical grooves in the side panels. Do I need to separate the top and bottom half of the front and remove the bottom part first?
smiley29.gif

I'll post some pictures in the morning to show what I'm talking about. I just hope that it can be done without disassembling the whole cabinet.
smiley5.gif
 

slowcade

Active member
Feedback
1 (100%)
Credits
204CR
Here is what I'm talking about. I have loosened all the bolts and brackets which hold the top half of the front panel in place.

si_front_01.jpg


There is a small wooden block that I have unscrewed. That also appeared to be glued to the front, so I stuck a blade in between the block and the front until it came loose.

The brackets that held the front in place (with bolts) are also visible in this picture. Now the top half of the front panel feels very loose.

Don't mind the rust and the obvious hack job.
smiley36.gif


si_front_02.jpg


But the problem is this.. The front panel goes into grooves in the side panels, like this:

si_front_03.jpg


That makes it difficult to simply slide the panel out.
smiley18.gif


So should I loosen the bottom half of the front panel first, or would I need to take apart the whole cabinet to swap the front panel?
smiley5.gif
 

Alpha1

Do the Shake and 'VAC
Staff member
vacBacker
Feedback
95 (99%)
Credits
5,653CR
I have often thought about this - but I have never tried it, can you not crank the sides open until the front panel is free to remove?
 

slowcade

Active member
Feedback
1 (100%)
Credits
204CR
Maybe.. I'm a bit hesitant to do it, as I would have to bend it almost 1 cm out.
I was under the impression that the swap would be a quick and simple job. If I risk damaging the cabinets I may have to pass.
smiley1.gif
 

slowcade

Active member
Feedback
1 (100%)
Credits
204CR
I did it! I have removed the front from one of the cabinets! It was a hell of a job, and I don't recommend it to anyone.
The panels are glued, nailed and screwed on, in so many locations and on all edges. I would never have done it if I knew how much work it was.
I did it with a combination of a hammer and one of those thin metal blades you use for plaster, plus forcing the sides out like Alpha1 suggested. It will be easier now that I know how, but this is the first and the last time that I'm ever doing this swap.
smiley36.gif
 
Top