Space Invaders not moving?!

andrewsm

Active member
Feedback
1 (100%)
Credits
485CR
Can anybody help me here with a really fustrating problem?

Restoring a Nichibutsu Moonbase Zeta table and after much head scratching and work I now have the boards (3off) booting fine and going though the attract mode except as soon as the invaders appear they shift down and then stop. The player ship moves across from left to right and then nothing. If I insert a coin, then the usual Player 1 stuff appears. All graphics seem ok and quite a few parts have been changed as Ive been chasing one fault after another. They were all dead boards to start with.

invaders.jpg


I had the the code running in a 27256 eprom mod but decided to insert the original 2708 eproms back in to rule out any software issues.

Any help would be appreciated as im sort of going round in circles atm.
 

andrewsm

Active member
Feedback
1 (100%)
Credits
485CR
Update.
Ive now replaced a few more chips in the shifter circuit after poking around a bit more. Now my invaders are perfectly formed but.... still dont move once they have dropped down at the start.

Does anyone one here know about this or seen it before either on Moonbase or Midway invaders???

Cheers

Mark
 

andrewsm

Active member
Feedback
1 (100%)
Credits
485CR
Think I might have seen this but will look thanks. I've since focussed on a iffy signal I found by chance. this lead me back to a bad counter chip in the video?! Just waiting on a replacement so fingers crossed.
 
Top