Space Invaders Pinout

alfa75

Active member
Feedback
19 (100%)
Credits
96CR
Hi

I have a space invaders board which I would like to test, but unfortunately I have no idea how the pin assignment is. I have already look at the Schemes https://www.mikesarcade.com/cgi-bin/spies.cgi?action=url&type=pinout&page=SpaceInvaders.txt and http://www.arcade-museum.com/pinouts-game/9662.html and none of these two agrees with this board (see below).
$_57.JPG


Thanks for help, alfa75
 

alfa75

Active member
Feedback
19 (100%)
Credits
96CR
Thanks t-m, but if I count the number of pins on the soundboard (Daughterboard) I come to 17 and this does not match the pinout on this scheme.
 

t-m

Active member
vacBacker
Feedback
2 (100%)
Credits
333CR
Check the note in the doc, some of them don't have the 3 unused pins on the left connector (in your pic). Don't forget to count the 'key' pins
 

alfa75

Active member
Feedback
19 (100%)
Credits
96CR
Yes, I've already see it, but I count only 10 Pins on the left side and in the note of the doc are listet 11 Pins in use. The same are on the right side there are 8 Pins listet but I've count only 7. What do you mean with the key pins? Thanks a lot!
 

t-m

Active member
vacBacker
Feedback
2 (100%)
Credits
333CR
The 'key' in the doc refers to the missing pin in the connector put there so you couldn't put it on back to front. So if you're counting the pins on the board also count the ones that aren't there
smiley36.gif


So yours is the same as the doc, you'd need an 11 pin plug on the left and 8 on the right.
 

simonden

Active member
vacBacker
Feedback
20 (100%)
Credits
1,042CR
The space in between the 2 connectors is the 'key' pin. It is spaced by 1 pin so a single connector can be put on the board with a 'key' (the hole is filled on the connector ) so that the connector is not put on the wrong way round.

Count the space as a pin and ensure that lines up as the 'key' in the pinouts.

EDIT: as he said ^^

simonden2016-11-16 09:50:53
 

david_orton_2000

Green Mario
vacBacker
Feedback
8 (100%)
Credits
344CR
Also, do always also do a 'sanity' check, i.e. ensure the 0v is actually to 0v and +5v, etc.
Now and then over the years, the odd pinout is in fact backwards!

BTW, if you want to get some sort of useful video, trace back slightly to just before the 2 resistors (which are used to combine the signal to composite), I just used some crock test leads, but anyway thought I would mention just in case. ;-)

-I think RGP James made a UTube video of making/using a test harness (to Jamma) so have a look there also.

Good luck.

Cheers,

DaveO.
 

alfa75

Active member
Feedback
19 (100%)
Credits
96CR
Now, I've test another Space Invaders (SI Deluxe) Board, but I'm didn't understand exactly how the Power on Reset runs. When I connect this to the ground I have a loop (look at the images).

DSC00667.JPG


DSC00669.JPG


Thanks!
 
Top