Space invaders pt2

Spud

Newbie
vacBacker
Credits
55CR
IMG_4847.jpg

This is my space invaders Pt2. Where do I start? Is this a ROM issue?
 

TheDaddy

Senior Member
vacBacker
Feedback
14 (93%)
Credits
7,230CR
Always check voltages first. Then I start at roms and forward from there. The screen gives no info , this could literally be anything !

Good Luck,

Dave.
 

bones

Active member
Feedback
15 (100%)
Credits
1,628CR
Has it ever worked for you ? Is this in it's original cab with original power supply ? It's just because this era taito boards have a ' power on reset ' feature built into the power supply connecting to the edge connector that needs overcoming to get it to boot up properly. Had it with a field goal PCB that had similar issues as with your screen. I was lucky in that it only required a momentary switch to sort it out but I believe SI part 2 requires a few components. A good way to tell is to short the tilt pin to 0v and see if the tilt text displays on the screen, if it does then it probably is just the POR missing.
 

Spud

Newbie
vacBacker
Credits
55CR
Its all original, a 3 board taito cab with original power supply. It has worked and was repaired by Arcader a good many years ago.
I checked the voltage and all measures correct. I know about the power on reset so will look there next.
 
Top