Spy Hunter pcb

ben76

Hunts Spies
Feedback
7 (100%)
Credits
1,136CR
Hi guys,

My pin and L2000 cab are still round my mums from play expo so lets try to get Spy Hunter going!

I've messed with a few boards and got this far.....


Tools I have are a multi meter, soldering iron and logic probe (not 100% on using the probe though
smiley9.gif
)

Any help appreciated
smiley27.gif


- Ben
 

Purity

The Oracle
vacBacker
Feedback
17 (100%)
Credits
2,999CR
I'm no expert but the first thing I tried on the Mr.Do PCB is whether the roms checked out ok. Other members advised checking the reset line, clock, voltage, and a few things listed here:

http://www.ukvac.com/forum/help-me-fix-a-mrdo-pcb_topic335423.html

Does the Spy hunter use a z80?
Purity2013-10-20 20:12:39
 

guddler

Busting vectors like it's 1982!
vacBacker
Feedback
10 (100%)
Credits
4,058CR
Don't worry too much about the voltages. They'll be important eventually but for now MCR boards will work right down to about 4.3v provided...

There's a 'reset' wire on the loom. Remove it. I'll look up which one it is. There's a feedback loop which holds the game in reset until it's happy the voltage has stabilised. It's not really required and for now may be more trouble than it's worth.

I'll be honest and say I don't think it's that, but it won't hurt. The other thing to try is to remove the SSIO board and just leave the CPU board and Video boards connected. The screen will be upside down if it comes up and show a 'Sound I/O error' message, but if you get that far then we know where the problem lies.

My money is either on the reset circuit or the CPU board at this point though as that is constantly resetting (which makes me think CPU board, NOT reset circuit really).

All this is based on it being an MCR set same as Tron but I can't remember if Spy Hunter is MCR 1, 2 or 3 off hand. I'll go dig out some manuals.

guddler2013-10-20 21:05:39
 

DanP

Administrator
Staff member
vacBacker
Feedback
5 (100%)
Credits
2,232CR
SH is MCR3. I would defo remove the reset line as suggested. You can get away with bending the pin out of alignment for a quick test (well you can on Tron). I'd still test the voltages (on the PCB) just to eliminate it from our enquiries.

Dan
 

guddler

Busting vectors like it's 1982!
vacBacker
Feedback
10 (100%)
Credits
4,058CR
Looks like the reset pins is the same one as on Tron.

Pin 17 of connector J1 (a 20 way) on the CPU board, or remove it from pin 15 of Connector 4, a 15 position one one the PSU board end (which IIRC is what I did on Tron). According to the manual it should be purple. Again, the same as Tron - but don't rely on that.
 
Top