Stager VS4800 EPROM programmer

darranallen

Newbie
Credits
10CR
Just bought a Stager VS4800 EPROM programmer, trying to set this up on a Windows 8.1 PC and it's not playing ball when i try to set up the USB driver, which in turn means the VSpeed software can't see the programmer.

Anyone had similar problems, or know how to fix?

Thanks in advance,

Darran
 

Macro

Active member
vacBacker
Feedback
4 (100%)
Credits
2,010CR
is it 32 bit or 64 bit, some of the drivers only work on 32 bit windows ?

if so, it might work if you use the XP mode and run a virtual XP machine for the software.

for mine, I had to find a 64 bit driver and load it using the 'allow unsigned drivers' bit - which is a pain but at least it works. (my programmer is a Xeltec, but similar principle probably applies)
 

obcd

Active member
Credits
3,830CR
Does it give you the "new usb device found" information when you connect it to the pc? If that isn't happening, the unit or usb cable are bad. (Unless it found a driver for it or uses a wrong driver)

If it loaded a driver for the device, you should find that new device in the hardware list of your computer. You can replace the driver it's using there.
 

darranallen

Newbie
Credits
10CR
No it doesn't, checked through everything in 'manage hardware' even uninstalled all the USB drivers and still doesn't show up with "new usb device found" when i plug it in. On the first install on windows 8.1 it did try to install but wasn't compatible, hence going back to XP. I'll try a new lead later.

How would i know if it was using a wrong driver?
 

obcd

Active member
Credits
3,830CR
With a wrong driver, it might show up in the hardware list, but the software still wouldn't be able to find the programmer. Is the programmer having a separate power supply? In such case you will need to connect that before you connect your usb cable. This often happens with devices generating an usb serial port. If they don't have a unique vedor and product id. (you have to pay for those) they often use the generic ftdi id's. In such case, the standard ftdi driver can be loaded.

In your case, it looks like the programmer is defective. Another possible problem is the device needing 2 much current on it's usb port. The maximum allowed is 0.5 amps. Most computers can deliver more but laptops sometimes can't deliver enough. A self powered usb hub can help in such occasions. (The hub needs a separate power adapter or the situation will be even worse.)
obcd2015-08-10 11:48:46
 

darranallen

Newbie
Credits
10CR
Tried a powered USB hub, swapped the leads for a new one, still doesn't show. Contacted the supplier (in China), let's see what happens.

Thanks for the help.

Darran
 
Top