Strange Controls

tazfaedodge

Active member
Feedback
3 (100%)
Credits
91CR
I have a single slot NeoGeo Motherboard in my Jamma Cab and have only been playing single player so far.

Just changed the cart and it must have not made a good connection as I got the config menu up, So I thought I would have a look and moke sure things are ok wile I had it open.

The strange thing that I noticed was that when I press the buttons for A,B,C I get an input in player 1 and 2 at the same time but button D that I added work one player at a time.

Do I have to change something? Will this cos problems in fighting games?

Nick
 

RGP

Meeter & Greeter
Feedback
5 (100%)
Credits
2,039CR
Sounds initially like your cab has been wired in parallel for player 1 and 2 controls. I have seen this on one can before at least.

Trace back the wires from the edge connector to the buttons.

If it's only just started then it could be your neo but more likely some wiring issues
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
i fixed OTTOS cab that was teh same, both 1 and 2 players where parallel wired

i since fixed it by relooming the whole cab

check with a multimeter if you get continuity if you touch the main button wire on both 1 and 1 player button 1 and so on
 

tazfaedodge

Active member
Feedback
3 (100%)
Credits
91CR
I've never had this cab running anything else so don't know what it was used for before I got it.

If it is wired that way, what would I have to do?

Nick
 

chadsarcade

Lord of Vectors (tm)
Feedback
11 (100%)
Credits
443CR
Some cabs (e.g. BAS) have a connector that if joined together will parallel the 1P and 2P buttons. This is so that the player can use either the left or right set of buttons if a single centre joystick is fitted. I imagine the wiring looms are generic for various layouts.

It's worth looking to see if you have such a connector - usually situated under the control panel somewhere near the buttons etc.
 

tazfaedodge

Active member
Feedback
3 (100%)
Credits
91CR
Is it one of these?

bdcbfcec-8fa5-4d74-bae6-94626ec58146.jpg


DSCF1539.jpg


Nick
 

chadsarcade

Lord of Vectors (tm)
Feedback
11 (100%)
Credits
443CR
The reddish connector in your bottom pic looks a potential candidate.

Trace it back - one side may go to P1 buttons 1,2,3 and the other half to P2 buttons 1,2,3.
Or
Separate the 2 halves and try your test again.
 
Top