System 1 Atari ,how to power amp from switcher ?
- Thread starter Body pop
- Start date
Thank you to everyone that helped me
That’s got it sorted 😀😀😀
Very happy to say the least
I stuck with the Amazon amp
Wired the pinouts to the switching power supply
The aux is still just split at the wire and soldered on to a new connector I made for the board
Separate transformer for monitor
Removed the old audio 2 board and the power brick
Really didn’t see me getting this sorted
So very happy
It may of worked if I’d of sent the right voltages to the audio 2
But I’m just happy to see it going
Thanks again guys
That’s got it sorted 😀😀😀
Very happy to say the least
I stuck with the Amazon amp
Wired the pinouts to the switching power supply
The aux is still just split at the wire and soldered on to a new connector I made for the board
Separate transformer for monitor
Removed the old audio 2 board and the power brick
Really didn’t see me getting this sorted
So very happy
It may of worked if I’d of sent the right voltages to the audio 2
But I’m just happy to see it going
Thanks again guys
Funhouse71
Active member
Glad you got it sorted...pretty sure I ran my adapter with just -5v for the -15v as I never used a seperate -12v PSU to get my setup working
Funhouse71
Active member
Actually thinking about it again I may have converted the +12v to -12v using a -12v regulator and mounted it to the Jamma adapter will have to check all I know was there was no extra power supply it was all contained on the adapter itself
Interesting indeed .let us know if you do remember