(tech)Ghosts & Goblins

John Bennett

John Bennett

Senior Member
vacBacker
Feedback
10 (100%)
Credits
5,273CR
[ukvac] (tech)Ghosts & Goblins
Hello Peeps!

Just making a Jamma adapter for a Ghosts and goblins which is probably a bootleg (only board markings are 'made in japon'(thats not a typo it's japon!))

Anyhow checked out spies for pinouts-

http://www.spies.com/arcade/boardPinouts/GhostsNGoblins.txt

and there they are.

They don't however quite match up to mine although very similar. I wondered if anyone knows what the pins 22 & 23 are for marked ctrl1+ and -. or if anyone has pinouts for it which have 27 ground and 28 +12. It will just save me a lot of trial and error.

Many thanks Jake



DATA Imported from archives: originally posted by jake.lee (jake.lee@ntlworld.com)
 
system11

system11

Active member
Feedback
9 (100%)
Credits
345CR
Re: [ukvac] (tech)Ghosts & Goblins
ctr1+ and ctr2+ (22 component/solder) are actually hard linked to the 12v pins
(25 component/solder) - they're feeds for the coin counters. 26 and 28 c/s
should all be ground - I would expect the bootleg to match, but I've never
seen one.

On Sun, 10 Feb 2002 17:59:54 -0000
"jake.lee" <jake.lee@ntlworld.com> wrote:

> Hello Peeps!
>
> Just making a Jamma adapter for a Ghosts and goblins which is probably a
bootleg (only board markings are 'made in japon'(thats not a typo it's
japon!))
>
> Anyhow checked out spies for pinouts-
>
> http://www.spies.com/arcade/boardPinouts/GhostsNGoblins.txt
>
> and there they are.
>
> They don't however quite match up to mine although very similar. I wondered
if anyone knows what the pins 22 & 23 are for marked ctrl1+ and -. or if
anyone has pinouts for it which have 27 ground and 28 +12. It will just save
me a lot of trial and error.
>
> Many thanks Jake
>
>
>
 
You must log in or register to reply here.
Top