Tournament Arkanoid

vectrex

User
Feedback
9 (100%)
Credits
47CR
Hi, plugged in my formerly working Tournament Arkanoid after a few years and this is what it's showing:



Any idea where to start ? Video RAM ?

Thanks

Frank

vectrex2015-10-11 15:14:34
 

Layer

Active member
Credits
376CR
Oh, I see now.

Arkanoid original PCB uses the same PC030CM module that Bubble Bobble or Scramble Formation which dies with time.

Layer2015-10-11 16:50:14
 

Hurray Banana

Moderator
Staff member
vacBacker
Feedback
8 (100%)
Credits
2,756CR
vectrex said:
Yes +5V is okay (no problems with other boards).

Changed nothing concerning the adaptor and stored it a few years ago when it was working ...

have you tested the 5v at the board edge connector? it does look like under voltage artifacts
 

vectrex

User
Feedback
9 (100%)
Credits
47CR
Hi, yes I've tested the voltages on the PCB connector and they are fine. Tried adjusting the +5V (from 4 to 5.6 volts) - didn't change anything.

To me it doesn't look like the typical under-voltage-artefacts.

Here's another pic:

 

Layer

Active member
Credits
376CR
Have you tried to clean your board if it was a bit dusty, removing the eproms ?

The issue looks like +5V not adjusted, a TTL or a RAM nearly dead.

AnDyC said:
PC030CM Is for coin inputs/counters i doubt its causing this.

You're right, but I've never seen how the issue looks like, maybe it affects iO only.
 
Top