I've just had my Vectrex apart to clean the power switch (one side was staying open when switched on).
I seem to have fixed the switch but now have a strange issue that I haven't seen before. The image is only visible in the top-right quarter, and the vectors are not displaying correctly (see pic, that is Minestorm). Text seems to be only visible as one line and therefore not legible at all.
I can't be sure whether this problem had developed since I last used it, or is something I have inadvertantly done while cleaning the switch. I have checked connections and reseated socketted chips. Getting 2x 10.2VAC to the power board, and Minestorm seems to be happily running.
Anyone have any suggestions as to what else I could check?
I seem to have fixed the switch but now have a strange issue that I haven't seen before. The image is only visible in the top-right quarter, and the vectors are not displaying correctly (see pic, that is Minestorm). Text seems to be only visible as one line and therefore not legible at all.
I can't be sure whether this problem had developed since I last used it, or is something I have inadvertantly done while cleaning the switch. I have checked connections and reseated socketted chips. Getting 2x 10.2VAC to the power board, and Minestorm seems to be happily running.
Anyone have any suggestions as to what else I could check?