Vectrex Screen Alignment

Vorbis

Active member
Feedback
6 (100%)
Credits
837CR
I've just noticed that the screen on the Vectrex I bought at the weekend is out of alignment. I probably should have noticed earlier but I hadn't tried out the screen overlays which make it a lot more noticeable. It looks off centre and slightly reduced in size to me. Is realignment an easy job for someone with barely the skills to wire a plug (I usually refer to the instructions
smiley36.gif
) or is there anyone in the Suffolk / Essex area that I can pay to do it for me.

Resizer_16383656053870.jpg


Thanks
 

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,092CR
Hey, Paul. The first thing I'd do is 'zero the DAC', as this should be done at some point, and adjusting it affects screen centring. You need a multimeter and test cart (included on PiTrex and most multicarts).


To centre the screen, you need to adjust the 2 metal rings on the yoke, shown here:

vectrex_rings.jpg


There's little tabs on the rings to make adjusting them easier. They may be held in place with red (usually) thread lock, in which case, you'll need to gently break the seal. It's easiest to adjust the rings to get the centring right with the Vectrex on, but if you're not happy doing that, you can always try adjusting a bit before switching on to check.

big10p2021-12-01 14:27:27
 

Vorbis

Active member
Feedback
6 (100%)
Credits
837CR
Thanks for the advice Chris. I think I'd be better off paying someone who has a clue to do it though, I don't have much success with DIY
smiley36.gif
Would it be something a TV repair place could do do you think or can anyone recommend someone in the Suffolk / Essex area that can do this kind of stuff. If I could sit and watch someone do it in person I'd probably be OK the next time, I don't have the best record of following instructions in YouTube videos
smiley4.gif
 

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,092CR
If there's a willing volunteer near you with a bit of hands-on arcade experience, they should be able to do this, even if they have no Vectrex experience. Also, if you're lucky, you may find that zeroing the DAC brings the screen back to centre, and you don't need to mess with the rings at all.
smiley1.gif
 
Top