Wells Gardener 19V1001

[Ronnie Dent]

Accurate feedback is important as well.

Good to hear all are working now.

Thanks, I'm sure this thread will be valuable for others too

Ronnie

 

[Alpha1]

Nice work guys

 

[Ronnie Dent]

Well the joy was short lived! I took the spare chassis out (still working well) and put back the 1st chassis which had all the work done and after power on it looks like I have screen collapse? just a horizontal line in the middle of the screen, could this be the hot transistor given up?

Thanks Ronnie

 

[obcd]

Very unlikely. Are you sure the vertical deflection coil is properly connected to the chassis? Maybe a wire became loose or the connector is having a bad soldering.

 

[Ronnie Dent]

Very unlikely. Are you sure the vertical deflection coil is properly connected to the chassis? Maybe a wire became loose or the connector is having a bad soldering.

Good call, stupid me fitted green and red wrong way round on the yoke coil! I must pay more attention could have caused damage but it's working fine.

My 2 boardsets have been repaired and on way back to me, fingers crossed the machine will work for a long time.

Many thanks again for pointing in the right direction

Ronnie