Morning All,
Got a practical issue with my WG monitor.
I'm running MAME on it through a jpac, and have recently switched to Attract Mode.
I
don't have a lot of vertical pcbs, only 2 in fact, but whereas they
display their image the right way up, as did the old MAME system, the
Attract Mode image is now upside down.
As there doesn't seem to
be an easy way to rotate the Attract Mode image through 180 degrees in
software (it will only tate 90 degrees), I was wondering if there was a
simple way of doing it on the JPAC or WG chassis that didn't involve
clipping and rejoining the wires to the yoke?
Any tips appreciated.
Cheers,
Got a practical issue with my WG monitor.
I'm running MAME on it through a jpac, and have recently switched to Attract Mode.
I
don't have a lot of vertical pcbs, only 2 in fact, but whereas they
display their image the right way up, as did the old MAME system, the
Attract Mode image is now upside down.
As there doesn't seem to
be an easy way to rotate the Attract Mode image through 180 degrees in
software (it will only tate 90 degrees), I was wondering if there was a
simple way of doing it on the JPAC or WG chassis that didn't involve
clipping and rejoining the wires to the yoke?
Any tips appreciated.
Cheers,