WG 6100

petercasino

Active member
vacBacker
Feedback
8 (100%)
Credits
212CR
I've got a WG6100 vector monitor that's got a dot in the centre of the screen when switched on. Is this because the brightness is too high? If it is, what's the correct way to adjust the brightness on these monitors? There's a pot on the LOPT below the focus control but it's currently glued - is this what I should use?

Cheers,

Mike
 

Mitchell Gant

Active member
vacBacker
Feedback
2 (100%)
Credits
888CR
Yes that's the grid screen control you correctly found, you need to break the glue and turn it down a bit. It's pretty sensitive too, so make sure you don't turn it up or you risk burning a spot in the screen.
 
Top