WG6100

leslie

Active member
Feedback
3 (100%)
Credits
42CR
Hi all i have a wg6100 that has a problem witch is when turned on after a minute or so the transistors on the monitor frame get very very hot and by doing that i belive it causes trace lines to appear on the screen, has anyone else had this problem? or better still does anyone know what the solution is? thanks is advance .
 

Equites

Chief Sheesher®
vacBacker
Feedback
35 (100%)
Credits
3,329CR
The frame transistors are supposed to get hot. That's why they are bolted to the frame to dissipate heat. How hot are they getting?

Have you tried turning down the brightness on the HV focus block to eliminate retrace lines?
 

leslie

Active member
Feedback
3 (100%)
Credits
42CR
Thanks for the responce the monitor starts out with a perfect picture but after a minute or so the transistors get almost to hot to touch and i am unable to lose trace lines by reducing the brightness any more ideas please ?
 

edwoodjnr

Active member
vacBacker
Feedback
2 (100%)
Credits
246CR
I had this on my WG6100 where the other chassis transistors were warm but not hot and the one on the side was very hot.

I just replaced it with a new mica insulator and thermal paste. Not sure if the connection was bad or the transistor but it did the trick
 

leslie

Active member
Feedback
3 (100%)
Credits
42CR
Thanks for all your help guys i am making progress just fitted an LV2000 but the main problem is that i have no control over the brightness hence the trace lines but i can control the focus (there is no brightness control on the neck board so the only control is on the flyback, does any one know a cure for this ?
 

leslie

Active member
Feedback
3 (100%)
Credits
42CR
Thanks very much for that advice ,im not the best with eletrics but ZD902 gives me 565 (out of circut) and zero when i reverse poles , me thinks thats ok or am i wrong?
 
Top