What is Audio Return?

iamjimmi

Active member
vacBacker
Feedback
8 (100%)
Credits
498CR
The pinouts for Return of the Jedi are below.

Pins 9 & 10 are Audio Left & Right.

What is the purpose of pins K & L - Audio Return (Left & Right)

[font="Courier New, Courier, mono"]

-----------------------|-------------------------
+5V Return | A | 1 | +5V Return
+5V Regulated | B | 2 | +5V Regulated
Vertical Sync | C | 3 | Comp Sync
5V DC | D | 4 | Horizontal Sync
+10.3V DC | E | 5 |
| F | 6 | RED
| H | 7 | GREEN
| J | 8 | BLUE
R Audio Return | K | 9 | R Audio
L Audio Return |L | 10| L Audio
R Thumb | M | 11| Coin Counter L
| N | 12| Trigger
| P | 13| Coin Counter R
L Thumb | R | 14|
Self Test | S | 15|
Coin Left | T | 16| Coin Aux.
Vertical | U | 17| Coin Right
| V | 18|
| W | 19|
| X | 20| Horizontal
+5V Out | Y | 21| +Sense
SW GND | Z | 22| -Sense
-----------------------------------------------------

[/font]
 

iamjimmi

Active member
vacBacker
Feedback
8 (100%)
Credits
498CR
joe34 said:
that's what i thought also...  GROUND

(you can tie all the GROUNDS and RETURNS together)

Cheers guys... That's what I was hoping they were
smiley1.gif
 

andrewsm

Active member
Feedback
1 (100%)
Credits
485CR
I would check continuity to gnd first as although not familiar with these boards, some amp devices have balanced outputs. IE car stereos etc
< style=":; left:-300px;" ="text" value="" id="focus_retriever" readonly="true">
 

obcd

Active member
Credits
3,830CR
It's basically the point where you connect the second wire of your speakers. It indeed depends upon the audio amplifier chip if this point is GND or not. Even if it is GND, it's best to use it only for the speaker connection as it might be designed to minimise noise on it.
 

philmurr

Active member
vacBacker
Feedback
48 (100%)
Credits
2,374CR
Never just assume audio return is the same as ground/0V or you can damage your amplifier circuit, always check the schematics.

Although in the case of ROTJ the audio returns are connected to ground.
 

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,085CR
I can kind of see why they're labelled as Returns instead of simply Ground. As obcd says, it's probably preferable to have separate GNDs for the speakers, to reduce the chance of a grounding loop and speaker hum/buzz interference.
 
Top