What Solder do I use?

sherr03

User
vacBacker
Feedback
1 (100%)
Credits
103CR
Just started learning to solder again after about 25 years. Whats the best stuff to use now? I have some lead stuff but its really thick so not really suited to PCB's.
Any links would be greatly appreciated.
Thanks
 

ArcadePCB

User
vacBacker
Credits
509CR
If you want to solder (bigger sized) SMD parts also, I would recommend 0.7mm diameter instead of 1mm wire, same type as mentioned above (SnPb40 or SnPb38Cu2). It contains enough flux, too, but it's better for soldering smaller parts. I use this almost all the time.
 
Last edited:

John Bennett

Senior Member
vacBacker
Feedback
10 (100%)
Credits
5,324CR
For me:
0.46mm for super-fiddly surface mount
0.7mm for normal through-hole stuff
1mm for joining copper pipe with a blowtorch
I didn't have any bother ordering solder from Farnell recently :)
 

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,082CR
I just use 1mm 60/40 for everything, but I don't do any SMD stuff. I just make sure I use the right tip for the job.
 

Chihiro

I do this shit for a living yo!
vacBacker
Feedback
6 (100%)
Credits
1,008CR
Just don't buy cheap stuff off eBay as these brands typically use recycled metals, I use SRA solder from the US.
I also use some non acid safety liquid flux from Gaugemaster.
 
Last edited:

tronads

Active member
Feedback
5 (100%)
Credits
453CR
Yeah, the Ebay stuff is garbage. I ordered some "leaded", but when I used it, leaded my arse.
Stuck with the RS Pro now....but it will probably last me years.....my last lot that ran out last year was Radio Shack branded.
 

NivagSwerdna

Active member
Feedback
1 (100%)
Credits
849CR
It depends on what you are going to solder. I use three types... One for SMD and most components, another for the bigger components and connectors and another for solder jumpers.
If you can afford it treat yourself to some containing Ag, seems to work nicely.
You will need deep pockets but my go to is EDSYN SU35100 for the small stuff and some Antex for the bigger stuff. I use some eBay stuff for my solder jumpers because it doesn't flow!
IMG_20230424_093340671.jpg
 
Top