wonky wheel

Mr20to5

Active member
vacBacker
Feedback
1 (100%)
Credits
1,366CR
Hi guys.

The steering wheel on my Sega Scud (sit down) continuously seems to work itself loose when in use. I have replaced the bolt and washer that secure it to the shaft, and although much better, it still eventually works itself loose, which results in the wheel rocking back and forward during use.

I've now started keeping the bezel off and just nipping it up as needed, but would rather find the solution. Is it as simple as pouring a load of thread lock in there and leaving it? And if I did then what if I needed to remove the wheel/dash in the future?

Thanks in advance.

Neil.
 

Mr20to5

Active member
vacBacker
Feedback
1 (100%)
Credits
1,366CR
mathj said:
does the nut you are using have a nylock washer in the top?

Erm, no.

When I got it I was made aware prior about this. The bolt that was in when I got it was just called standard bolt which was only just long enough to reach threads on the shaft, so I replaced this with simply a longer standard bolt. But it doesn't have the nylock washer you mention.
 

obcd

Active member
Credits
3,830CR
If there is a little friction between the axe and the steering wheel, the bolt will unscrew itself after a while. To fix this, we weld a large nut on 2 sides of the bolt and drill a little 4 mm hole into that nut. We then fix the steering wheel with the bolt and mark the position of that hole on the steering wheel. Next, we drill a hole on that location in the steering wheel and tap some M4 thread into that hole. The space is limited but it's doable. Next, we refix the steering wheel and lock the bolt/nut combination with an M4 screw. The friction between the axe and the wheel might still exist, but the bolt can't unscrew anymore.
 
Top